How To Use A Bathroom Auger

August 11, 2021 Post a Comment

This is to prevent the toilet bowl from scratching. Put the augers end into the toilet bowl.

Is A Toilet Auger Better Than A Toilet Snake In 2021 Clogged Toilet Toilet Auger

With a little bit of effort and skill you can get your drain clear and running once again without a costly visit from the plumber.

How to use a bathroom auger. How to use a Toilet Auger - YouTube. Step 7 Remove the Blockage. This twists the corkscrew end of the cable into the clog.

Apply enough force to send the cord all the way down the curves. This may take a few minutes. Once safe and clear entry to the plumbing is gained it is time to begin snaking the drain.

It is important to hold the auger housing firmly with one hand at all times while turning the auger with the other to pull the cable into the drain. If a powered auger stops suddenly immediately release the throttle or hit the kill switch stop the motor. Begin turning the handle or start the motor.

Again consult your owners manual for greatest chance of success. If you work too rough the cable will not enter the drain faster but will only double. Dont use excessive force to get it in or you could damage the device and the drain.

Then place the lower part of the auger into the toilet. It is used to link the sink with the rest of the water system in the house. This will help you find the knack of holding the tool right position to stand and lean and so on.

Do this 2 or 3 times. When the entire length of the handle has been used up crank the handle in the opposite direction to retrieve it. This way the blockage will wrap around the cable and the cable will pull it out of the drain pipe.

Turn the Auger Handle. Then you can use the right type of auger for your type of drain. You should only be able to see the bent part of the auger that is covered in rubber.

The toilet auger is going to cut the clogs into small pieces that will fall down the drain and wash away. I dont mean going in and starting to unclog your drain but see if there is any hair or other objects lodged in the uppermost part of your drainage system that you can reach and get rid of without using an auger. Here are the steps to use this tool.

If it drains to the back curve the auger to the back. Hold the auger upright by the handle with the shank perpendicular to the ground. To remove the blockage start pulling the handle upwards while again rotating it clockwise.

In the case of sink drains the first thing you can do is remove the p-bend which is a distorted part of the pipe located below the sink. Slowly insert the auger into the drain. If theres a blockage wrapped around the cable when it reaches the toilet bowl you have successfully done your job.

It can be placed underneath when you retrieve the. Have a bucket standing by. Dont rush and aim to be very precise.

Curve the end of your toilet auger in the direction that your toilet drains. Learn where the motor switch power supply switch and other important keys are. So if your john drains to the front curve the auger to the front.

Clean out the drain. Youll actively be using your rubber gloves and the drain auger in many cases but make sure the rest are in an easily accessible area for when you need them Step 2. Insert the toilet auger down the vent stack and start cranking the handle clockwise while pushing it down.

You might meet resistance when pushing the cable through the P-trap the U-shaped section of pipe under the sink or at any other bend in the pipe. Now that you know what a drum auger is we will move ahead and tell you how to use one. Wiggle it back and forth and ease it in.

Depending if you are using the auger to unclog sink or bath drain there is one additional step to do before you start working. Learn to insert and remove the auger through the drain pipe a couple of times without feeding the auger deep into the drain. Stop when the rubber handle reaches the toilets crook.

Steps to Use a Drum Auger on a Toilet. Before going into the details keep in mind that you should not directly insert the drum auger to avoid scratching the surface of the toilet bowl. Pull the crank up from the handle as far as you can which will cause the spring of the auger to be right up against the end of the auger tube.

If so tighten the setscrew and crank the auger slowly while pushing on the cable. Slide the shaft in. You cannot learn while the auger is in use.

Now you have to release the cable by simply cranking the snakes handle clockwise. Slowly turn the crank handle of the auger. To use an auger properly you need open up access to the drain by removing any covers or plugs.

Using the Drain Auger.

Best Toilet Auger Toilet Keep It Cleaner Augers